Reference: 22-001

250 OHM Resistor

250 ohm resistor Suitable for analogue sensors with 4-20 mA output to be connected to Logger 3030, Logger 3030 PRO or Expansion module ADMIQ. The resistor gives an input of 1-5 V on the analogue inputs if coupled as described in the manuals. For the analog 0-12 V terminals (iADC) on Logger 3030, it may be  better to use a 600 OHM resistor as it provides...

Reference: 01-071

Current transformers 600 A SCT036TS 600A / 5A

Openable current coils 600A/5A The current coil fits the following electricity meters SDM630 MCT V2 MID, SDM630 MCT V2 non-MID, SDM120D CT-P, SDM120CTM MID, SDM120CTMB M-bus MID, SDM630 MCT M-bus V2 MID. SCT036TS-600A-5A Inner diameter of the coil is 35 mm. External dimensions: W: 66mm X H: 94mm X D: 46mm 1 piece (buy 3 pieces for three-phase electricity...

Reference: 04-002

Brand: Energibutiken, WebIQ AB

HTMIQ High temp module

HTMIQ High temp module for Logger 2020 and SunLogger 2020 With this module, you can measure temparatures in the range above 125°C (up to 400°C)

Reference: 27-001

Earth fault switch 4P, 40A, 30mA Type A

Earth fault switch 4P, 40A, 30mA Type A Standard earth fault switch for personal protection 30 mA, three phase max 40A.

Reference: 12-001

Itron CF ECHO II Qp 1.5 heat meter

Itron CF ECHO II Qp 1.5 heat meter Itron heat meter used to measure the energy and power in waterborne systems.The heat meter can be used eg to measure the output and the cumulative energy supplied by heat pumps, biomass plants and solar panels. Pulse/M-bus card as accessorie.

Reference: 01-042

Electricity meter Eastron DCM230 Modbus

Electricity meter Eastron DCM230 Modbus ATTENTION! Supply voltage 230V AC Very advanced electricity meter that has a counter, trip meter (which can be reset), power meter and much more (click "MORE" for full specifications). The electricity meter has an illuminated display, pulse output and connection for modbus RTU communication. Error display less than...

Reference: 13-007

Brand: Itron

Flow meter Qn 2.5 hot water

Flow meter Qn 2.5. Water meter Qn 2.5 hot water This water meter is suitable for measuring flows / water consumtion in villas, perhaps primarily in tap water systems or smaller heating systems. Recommended flow for installation in heating systems is max 2500 l / h Counter showing the water consumption in XXXXX.XXX m3 format. Horizontal or vertical...

Reference: 04-023

Heat conductive paste 20 grams

Heat conductive paste 20 grams This paste is great to use when installing a temp sensor to pipes, tanks or in temp pockets. A small amount of paste is enough to improve the measurement accuracy, particularly in terms of reaction times during sudden temperature changes.

Reference: 05-002

Brand: Energibutiken, WebIQ AB

Pressure Sensor 0-10 Bar

LONN-2SX Pressure transmitter 0-10 bar, 4-20 mA. The sensor is widely used in many different areas, such as various applications in both real estate, homeowners, industry and HVAC. The pressure sensor is small, lightweight and made of stainless steel ( EN 1.4301, AISI 304), o-ring seals makes it resistant to water IP 66

Reference: 01-077

Brand: Carlo Gavazzi

Electricity meter 3-phase Carlo Gavazzi EM330-HM1 M-bus for measuring with current coils

Electricity meter 3-phase Carlo Gavazzi EM330-HM1 M-bus for measuring with current coils Three-phase electricity meter with M-bus for measuring with current coils, model designation: EM330DINAV53HM1PFB for 3-phase (65A/400V). Approved for debit metering, used for net metering/production. Can be logged with Logger 1010 or Logger 3030 PRO Modbus, or with...

Reference: 25-029

Main switch / Load switch

Main switch / Load switch Intended as an incoming circuit breaker in standard power stations (power plant). The main switch can be locked in the off position with a standard padlock.

Reference: 06-001

Brand: Energibutiken, WebIQ AB

PT1000 TRANSDUCER to 0-10 volt

PT1000 TRANSDUCER WITH HOUSING The measuring transducer records the temperature via a connected Pt1000 sensor and coverts the value into a standardized analogue output signal in the range between 0-10V/4-20 mA. 24 measuring ranges can be selected and adjusted with the help of a DIP switch. The offset can be corrected by ±5K using the potentiometer.

Reference: 13-008

Brand: Itron

Puls module Cyble sensor 2W

Cyble Sensor pulse module with 1 pulse / liter Cyble communication modules have been designed to meet the requirements of MID for those who want to read their water meters.With hundreds of thousands of installed cyble sensors, we have proven that this patented technology ensures reliable remote reading of water meters, both when reading conter, but also...

Reference: 01-073

Single phase Carlo Gavazzi EM112-S1 Modbus MID

Single phase electricity meter for currents up to 100 A, Carlo Gavazzi EM112-S1 Modbus MID, EM112DINAV01XS1PFB

Reference: 02-061

Brand: Energibutiken, WebIQ AB

PT1000 high temp sensor 6 mm 400°C 3 meter

PT1000 High temp sensor -50 to +200°C 3-wire universal high temp temperature sensor suitable for Logger 2020's high temp module HTMIQSuitable for measurement of all media that does not get more than 400° C hot. This sensor can also replace sensors such as Danfoss ESMB-12

Reference: 15-006

Vibration damper Air to Water

Steel Spring Isolators. High-quality galvanized steel spring isolators that beats most when it comes to anti-vibration of Air to Water heat pumps, weight of the heat pump can be 100 - 200 kg. Be aware that these dampers are higher than most rubber dampers if you are to replace already fitted rubber dampers.

Reference: 12-002

Itron CF ECHO II Qp 2.5 heat meter

Itron CF ECHO II Qp 2.5 heat meter Actaris heat meter used to measure the energy and power in waterborne systems.The heat meter can be used eg to measure the output and the cumulative energy supplied by heat pumps, biomass plants and solar panels.

Reference: 01-060

Electricity meter single phase for coil Modbus

Affordable electricity meter with Modbus port and 2 pcs of pulse output with 1000 imp / kWh, import and export. One module wide, for current coil measurment, order coils separate.

Reference: 02-053

Brand: Energibutiken, WebIQ AB

PT1000 Universal temp sensor 6 mm 3 meter

PT1000 sensor, max 200°C, 3 meter 6 X 50 mm 3-wire universal temperature sensor.Suitable for measurement of all media that does not get more than 200°C hot.

Reference: 24-016

Reservdelsbatteri till Climatech K3

Reference: 14-001

Brand: Energibutiken, WebIQ AB

Epecon Förinställningsverktyg

Reference: 01-063

Distribution box for 4 modules, premium

Distribution box for 4 modules, white. For safe installation of relays and / or electricity meters for DIN rail. W X H X D = 110 X 180 X 82 mm

Reference: 17-003

Pool Spounge 18 pcs

Pool sponge 18 pcs 18-pack Melamine cleaning sponge, fantastically effective for cleaning the waterline in your pool, but also incredibly effective for cleaning plastic and / or and chrome pool details. Highly recommended by us, we use it ourselves both for the pool and in the kitchen / toilet - a must if you have not already tried!

Reference: 01-031

Distribution box 8 modules premium

Distribution box 8 modules Premium, white. For safe installation of electricity meters, relays, circuit breakers, earth leakage circuit breaker mm DIN rail.

Reference: 05-001

Brand: Energibutiken, WebIQ AB

Pressure Sensor 0-6 Bar

LONN-2SX Pressure transmitter 0-6 bar, 4-20 mA. The sensor is widely used in many different areas, such as various applications in both real estate, homeowners, industry and HVAC. The pressure sensor is small, lightweight and made of stainless steel ( EN 1.4301, AISI 304), o-ring seals makes it resistant to water IP 66

Reference: 03-033

Power Supply for Logger 1010 & 3030

Power supply 12 VDC 1 A Power supply suitable for Logger 2020, Logger 3030 and our M-bus Converter Plug-in, switching, stabilized output voltage. Wide input voltage range

Reference: 02-052

Brand: Energibutiken, WebIQ AB

Temperature - Humidity - Light-sensor module THLIQ-02

Temp / Humidity / Light Module THLIQ-02 High quality module with built-in temperature, humidity and light sensor, based on temp/humidity sensor Bosch GY-BME280. Fits Logger 3030 and Logger 3030 PRO Modbus

Reference: 01-078

Brand: Carlo Gavazzi

Electricity meter 3-phase Carlo Gavazzi EM330-HS1 Modbus for measuring with current coils

Electricity meter 3-phase Carlo Gavazzi EM330-HS1 Modbus for measuring with current coils Three-phase electricity meter with Modbus for measuring with current coils, model designation: EM330DINAV53HS1PFB for 3-phase (65A/400V). Approved for debit metering, used for net metering/production. Can be logged with Logger 1010 Modbus.